Wera - 338 Actuation tool for terminal blocks (spring cages) 0.6x3.5x81 - 05008102001

• Special tool for unlocking contact springs in electrotechnical line terminals
• Due to the curved geometry, even terminal blocks that cannot be reached with normal screwdrivers can be operated
• Suitable for spring terminals with a conductor cross-section of up to 1.5 mm² and 2.5 to 4.0 mm²

Due to the curved geometry, even terminal blocks that cannot be reached with normal screwdrivers can be operated

Operation of tension spring terminals

Terminal blocks hold the wire ends mechanically. The force required for this is applied by a spring in the case of tension spring terminals. The spring must be opened by a tool in order to be able to insert the wire ends. The special actuation tools from Wera allow operating the tension spring terminals - even in tight spaces such as switch cabinets. The curved blade also allows spring terminals to be reached where straight-blade tools cannot be used.

Keep your hands free

The blade tip stays in the terminal block, leaving both hands free to insert the end of the wire.

Prevents hand injuries

The outstanding design of the Kraftform handle that fits perfectly into the hand prevents hand injuries such as blisters and calluses.

Non-roll feature

The hexagonal non-roll feature prevents any rolling away at the workplace.