Engineer - Solder Sucker - Desoldering Pump - SS-02

Innovative Silicone nozzle-tipped, high-power, desoldering pump.

• Teflon Tip There should be a gap between nozzle and board to avoid heat of soldering iron.
• Silicone Nozzle : Elastic and heat-resistant
• Nozzle can stick to soldering iron on board closely and suck up solder powerfully with less residue. 
• Low maintenance cost owing to spare tube only required for replacement
• High-power and efficient absorption by means of elastic nozzle contact 
• Self-cleaning shaft allows high productivity of continual work without clogging 
• Body 20mm x 153mm 
• Weight: 52g 
• Cylinder capacity: 9cc

Features  

       

SS-02: Press down the nozzle elastically to cover the soldering point entirely. Absorb the melted solder very efficiently with less residue left on the board.

When a traditional solder sucker is used, there should be a gap between nozzle and board to avoid the heat of the iron tip and the suction power is reduced.

Plunger on the top is within easy reach of thumb.  It is ideal for one-hand operation in continuous work.

Self-cleaning shaft works in every stroke of the plunger, which requires easy maintenance.

Cleaning and Maintenance

1. For cleaning, unscrew the body while holding the nozzle unit. (Do not try to remove the plunger unit.)

2. It is occasionally necessary to wipe off solder residue and stain around the screw threads/spring with a cotton applicator or a cloth. 

3. After the cleaning is finished, apply silicone grease to the screw threads and the inside of cylinder with a cotton tip. It is useful to keep the cylinder airtight and have the O-ring packing slide smoothly.

Specifications