Engineer - Micro Connector Crimping Pliers - PA-24

PA-24 Micro Connector Crimping Pliers

• More than 170 different terminals applicable
• Specialty of 2.5mm pitch connector contacts of different connector manufacturers, works with JST XH, PH, EH & NH series, Molex Micro-Fit, KK series, etc. AWG #32-#18
• Specialty of 2.5mm pitch connector contacts of different connector manufacturers, works with JST XH, PH, EH & NH series, Molex Micro-Fit, KK series, etc. AWG #32-#18
• 6 Crimping Dies ('m'-shaped crimp: 1.3, 1.6, 1.9 & 2.2mm in width & Round crimp: φ1.4 & φ1.8mm) for open-barrel contacts
• Built-in screw cutter (M2, M2.6 & M3)
• Tapered and slender jaws, Light weight of 115g only
• Spring loaded (on the back side), with locking latch for easy handling

Features

Round Dies (For DuPont contact etc.)  [φ1.4 & φ1.8mm]

Wrap triangular lugs of the barrel around the insulation without damage.

How to select the suitable crimping dies 

1. Measure the width of conductor barrel or insulation barrel with
a caliper while both barrel lugs are adjusted in parallel.

2. Select the die width that is close to the width of barrel lugs measured.   Example: 1.5mm measured -->> Select 1.6mm dies.

3.Conductor Barrel (Lug) Crimping :

It is better to offset the rearmost edge of conductor barrel (lug) 0.1-0.2 mm from the edge of the upper die to form a bellmouth on the edge of the crimped barrel. (as per the figure on the right)

 

Insulation Barrel (Lug) Crimping : 

Set the insulation barrel (lug) at the center of the upper die in depth to keep the barrel (lug) horizontal when crimping.