Pressure plates can be replace by hand – no tools required (from 80 mm throat depth)
With protective caps on the clamping surfaces
Stable profiled rail with serration
BESSEY anti‐slip system (from 80 mm throat depth)
Technical data
Order number
Opening
Throat depth
Rail
Weight
mm
mm
mm
kg
TG10-2K
100
50
15x5
0.26
TG12-2K
120
60
20x5
0.42
TG16-2K
160
80
25x6
0.66
TG20-2K
200
100
27x7
1.06
TG25-2K
250
120
29x9
1.54
TG30-2K
300
140
32x10
2.19
TG40-2K
400
175
32x10
2.7
Product description
Integrated BESSEY anti-slip system
Maximum safety is available with the integrated BESSEY anti-slip system, when clamping with a throat depth of 80 mm or more. A set screw that is molded into the sliding arm interlocks with the serration on the rail. This effectively prevents the clamp from dislodging or slipping away.
Reinforced malleable iron clamps
Both the upper and lower sections are produced from high-quality malleable iron and reinforced by shafts. The powder coating protects against corrosion and the characteristic shaft profile works as a reliable reinforcement against torsion forces.
High‐quality profiled rail
The BESSEY profiled rail from our own drawing plant has been especially optimised for clamps. The serration on six faces additionally prevents the clamp from slipping.
Pressure plate
For enhanced serviceability the pressure plate can be changed with no need for tools. It can be replaced very easily and quickly.
Areas of application
Interior fittings
Shell construction
DIY
Furniture and joinery works
Kitchen construction and shop fitting
Carpentry and woodwork
Powerful and rigid clamping
Safety informations
Clamping tools are not suitable for lifting, pulling or transporting.
Clamping tools may only be clamped manually without using any auxiliary tools.
Improper use can cause personal injuries or material damage.
Never change or modify clamping tools. Only use them in their original condition. Only use original‐spare parts if required.
Material / Surface
Upper and lower section made of reinforced malleable cast iron, powder-coated
Hollow profile rail made of steel, cold-drawn, galvanised
Spindle with trapezoidal thread in rolled steel, burnished
Handle made of 2-component plastic
Pressure plate made of steel, cold pressed, galvanised
Protective caps made of plastic
Care instructions
Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
Clean the rails with solvent.
Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
Clean the fluting on the rails with a steel brush.
Clean and oil the spindle regularly.
If the lower part slips, turn the grub screw a 1/4 turn further (TG, KRE, KREV only).
